Bruce's Homepage

Kuat Systems Engineering Delta-7 Aethersprite (Jedi Starfighter)
Dimensions: 27.5 x 15 x 6.8 studs
Pieces: 250
Instructions: None

The Jedi Starfighter alludes to the later designs of the A-Wing and the Imperial Star Destroyer. It can be seen chasing/being chased by Jango Fett at the controls of Obi-Wan KenobiI made this as soon as official pictures of it came out, so I had to make due without schematics or official measurements. In retrospect it is fairly accurate considering. getting the right angle on the body was pretty difficult without newer wedge plates so I had to SNOT it. This is at mini-fig scale since one being at a one foot to one stud ratio wouldn't be able to fit a mini-fig. I plan to redo this with newer pieces (namely the canopy off LEGO's version of it) and measure it thoroughly to make sure lengths are correct (or at least proportional.

Image 1 Image 2 Image 3 Image 4

Questions/Comments: bruce@kus-numa.netBack to Top | LEGO Star Wars

Copyright © 2000-2003 Bruce Lowell. All rights reserved. Disclaimer.
Bruce's Homepage -
A part of the Kus-Numa Network -